Drift alignment seems to be a major stumbling block for amateurs who want to move up to serious astrophotography (i.e. photography through a telescope).
Here is good method to align your telescope to the pole using the star drift method. This is a classic method from the 1980s when electronics for telescopes was just a drive corrector.
- Set up your scope as normal. Use one of the many methods to roughly align using Polaris. This can be as rough as just getting Polaris in the centre of your finder scope. The closer you get here, the shorter the time you will spend drifting. If you’re using a tripod, level it first – it makes life easier.
- Put a diagonal and illuminated guiding eyepiece in your scope. (Omit the diagonal for a Newtonian.) About 200 power is the minimum needed for adequate sensitivity during drifting. Rotate the eyepiece so that a star moves parallel to the crosshairs in Declination (Dec.)and Right Ascension (R.A.) when using the slow motion controls. Align it so that Dec. is up and down (North & South) and R.A. is right and left (East & West).
- Find a star very near the meridian and about +20 degrees declination and align it to the center of the guiding eyepiece. Let your scope track (you may guide in R.A. only if you wish) and watch for Dec. drift (up or down). Unless your alignment is very close, you will see drift in 5 to 30 seconds.
- If the star drifts up, turn the azimuth knob that makes the star move right in the field. If the star drifts down, turn the azimuth knob that makes the star move left in the field (These adjustments are reversed for a Newtonian). After adjustment, use the slow motion controls to re-center the star. Repeat this until there is no drift for at least 5 minutes. Note: If you see drift in less than 5 seconds at 200x, you are probably 10 or more eyepiece fields off in azimuth. Give the knob a good crank. This may have to be repeated 3 or 4 times to notice the drift slowing. If you don’t see any drift for 30 seconds or so, you may only be 1 or 2 eyepiece fields off. Make your azimuth adjustment accordingly. If after adjustment the star drifts in the opposite direction, you went too far.
- Find a star 15 degrees to 25 degrees above the Eastern horizon and about +20 degrees declination. Repeat (2) and use the guidelines from (3) and (4). If the star drifts up, adjust the elevation to move the star down. If the star drifts down, adjust the elevation to move the star up. Repeat until there is no drift for at least 5 minutes. (Note: You may use a star in the west instead of the east but the adjustments must be reversed, that is, if the star drifts up, adjust the elevation to move the star up and if the star drifts dawn, adjust the elevation to move the star down.)
- If you made a large correction in elevation (several degrees or more), go back and check the azimuth, otherwise you are done. With a little practice, it ought to be possible to complete the procedure before the end of twilight. Try it in your back yard until you are confident. This method is usually accurate enough for astrophotographs of up to 3 hours duration for small fields (less than 1 degree) and up to 2 hours for larger fields (up to 5 degrees) for declinations between +70 degrees and -70 degrees. For exposures longer than these and closer to the poles, a photographic method of polar alignment that is applicable only to permanent installations may be required.
- It must be emphasized that the star cannot drift at all for 5 minutes to achieve the exposure times stated above. If you judge the drift by bisecting a star with a line in an illuminated eyepiece the star must stay bisected for the full 5 minutes. Experience has shown that if the star has drifted as little as half it’s diameter then field rotation will begin to creep into long exposures.
[phpbay]astrophotography, 100, “”, “”[/phpbay]
Polar Alignment Videos:
[tubepress mode=”tag” tagValue=”Polar Alignment star drift”]
[phpzon keywords=”astrophotography” columns=”3″ paging=”true” num=”3″ maxresults=”48″ searchindex=”Books”]
Filed under: Astronomy Articles
Is it computerized or have a motor? If not, you’d need to hand-guide, which is a royal PITA. The easiest way to set it up is find your local astronomy club, and ask. Most would be more than willing to help. For just viewing its pretty easy, but for photography its a little harder because it has to be very precise. There are also tutorials online(google polar alignment). What I did, is put my camera on a tripod quick-release plate(plate that screws onto camera, and snaps into tripod), and tightened that onto the equatorial mount by the screws that hold the telescope in place. That isn’t guaranteed to work, but mine was close enough in size to work. Worth a try if you have all the parts.